To Log This Cache:
1) What constituent parts of the barrier island are you standing on? Explain your answer.
2) What type of barrier island is displayed here? Explain your answer.
3) Take a selfie with you and or group at ground zero. If you do not want to be in the picture, post an original object with your picture. Plain picture with no object(s) or person(s) will NOT be accepted
NOTE: cell phone service may be not so good in this area. You can try to connect to the free wifi from Oval Beach to help.
Barrier islands are a coastal landform, a type of dune system and sand island, where an area of sand has been formed by wave and tidal action parallel to the mainland coast. They usually occur in chains, consisting of anything from a few islands to more than a dozen. They are subject to change during storms and other action, but absorb energy and protect the coastlines and create areas of protected waters where wetlands may flourish. A barrier chain may extend for hundreds of kilometers, with islands periodically separated by tidal inlets. Sometimes an important inlet may close permanently, transforming an island into a peninsula, thus creating a barrier peninsula, often including a beach, barrier beach. Though many are long and narrow, the length and width of barriers and overall morphology of barrier coasts are related to parameters including tidal range, wave energy, sediment supply, sea-level trends, and basement controls. The amount of vegetation on the barrier has a large impact on the height and evolution of the island.
Constituent parts:
Upper shoreface
The shoreface is the part of the barrier where the ocean meets the shore of the island. The barrier island body itself separates the shoreface from the backshore and lagoon/tidal flat area. Characteristics common to the upper shoreface are fine sands with mud and possibly silt. Further out into the ocean the sediment becomes finer. The effect of waves at this point is weak because of the depth. Bioturbation is common and many fossils can be found in upper shoreface deposits in the geologic record.
Middle shoreface
The middle shoreface is located in the upper shoreface. The middle shoreface is strongly influenced by wave action because of its depth. Closer to shore the sand is medium-grained, with shell pieces common. Since wave action is heavier, bioturbation is not likely.
Lower shoreface
The lower shoreface is constantly affected by wave action. This results in development of herringbone sedimentary structures because of the constant differing flow of waves. The sand is coarser.
Foreshore
The foreshore is the area on land between high and low tide. Like the upper shoreface, it is constantly affected by wave action. Cross-bedding and lamination are present and coarser sands are present because of the high energy present by the crashing of the waves. The sand is also very well sorted.
Backshore
The backshore is always above the highest water level point. The berm is also found here which marks the boundary between the foreshore and backshore. Wind is the important factor here, not water. During strong storms high waves and wind can deliver and erode sediment from the backshore.
Dunes
Coastal dunes, created by wind, are typical of a barrier island. They are located at the top of the backshore. The dunes will display characteristics of typical aeolian wind-blown dunes. The difference is that dunes on a barrier island typically contain coastal vegetation roots and marine bioturbation.
Lagoon and tidal flats
The lagoon and tidal flat area is located behind the dune and backshore area. Here the water is still, which allows fine silts, sands, and mud to settle out. Lagoons can become host to an anaerobic environment. This will allow high amounts of organic-rich mud to form. Vegetation is also common.
Types of Barrier Islands:
Wave-dominated
Wave-dominated barrier islands are long, low, and narrow, and usually are bounded by unstable inlets at either end. The presence of longshore currents caused by waves approaching the island at an angle will carry sediment long, extending the island. Longshore currents, and the resultant extension, are usually in one direction, but in some circumstances the currents and extensions can occur towards both ends of the island (as occurs on Anclote Key, Three Rooker Bar, and Sand Key, on the Gulf Coast of Florida). Washover fans on the lagoon side of barriers, where storm surges have over-topped the island, are common, especially on younger barrier islands. Wave-dominated barriers are also susceptible to being breached by storms, creating new inlets. Such inlets may close as sediment is carried in them by longshore currents, but may become permanent if the tidal prism (volumn and force of tidal flow) is large enough. Older barrier islands that have accumulated dunes are less subject to washovers and opening of inlets. Wave-dominated islands require an abundant supply of sediment to grow and develop dunes. If a barrier island does not receive enough sediment to grow, repeated washovers from storms will migrate the island towards the mainland.
Mixed-energy
Wave-dominated barrier islands may eventually develop into mixed-energy barrier islands. Mixed-energy barrier islands are molded by both wave energy and tidal flux. The flow of a tidal prism moves sand. Sand accumulates at both the inshore and off shore sides of an inlet, forming a flood delta or shoal on the bay or lagoon side of the inlet (from sand carried in on a flood tide), and an ebb delta or shoal on the open water side (from sand carried out by an ebb tide). Large tidal prisms tend to produce large ebb shoals, which may rise enough to be exposed at low tide. Ebb shoals refract waves approaching the inlet, locally reversing the longshore current moving sand along the coast. This can modify the ebb shoal into swash bars, which migrate into the end of the island up current from the inlet, adding to the barrier's width near the inlet (creating a "drumstick" barrier island). This process captures sand that is carried by the longshore current, preventing it from reaching the downcurrent side of the inlet, starving that island.