Skip to content

스트라이크 라인 및 딥 / Strike line and dip - D_Leslie_A EarthCache

Hidden : 12/29/2025
Difficulty:
4 out of 5
Terrain:
2 out of 5

Size: Size:   other (other)

Join now to view geocache location details. It's free!

Watch

How Geocaching Works

Please note Use of geocaching.com services is subject to the terms and conditions in our disclaimer.

Geocache Description:


이 어스캐시의 학습 목표는 GZ 위치 연구를 통해 기록자들에게 경사각과 층리각이라는 지질학적 개념을 익히게 하는 것입니다.

이곳 암석은 경사각, 층리각, 파쇄각을 보여주는 훌륭한 사례입니다. 아이야, 이름은 다양하지만 암석이 어떻게 변형되고 파쇄되었는지를 종합한 동일한 현상을 의미합니다. 이를 통해 암석은 우리가 이곳에서처럼 관찰할 수 있는 경사각을 형성합니다. 아래 질문에 답할 수 있도록 설명문을 주의 깊게 읽어보세요.

 

분열면
분열면은 암석이 쉽게 갈라지는 특정 표면을 말한다.

분열면은 특히 셰일 같은 암석에서 두드러지며, 이 암석들은 크고 얇은 조각으로 채취되어 슬라브나 지붕용 슬레이트로 사용된다. 분열면은 화강암 같은 대량 화성암에서도 발견되며, 이러한 암석의 파쇄를 가능하게 한다. 예를 들어 화강암에서 가장 우수한 분열면은 수평이거나 약간 경사진 것이다. 그 다음으로 암석의 자연적 층리가 이어진다. 이와 직각을 이루는 방향에는 덜 우수한 분열면이 존재한다. 또한 다른 두 분열면에 수직인 제3의 “야생 분열면”이 있을 수 있다.

따라서 분열면은 암석이 특정 평면이나 약한 영역 내에서 어떻게 갈라지거나 분할되어 이러한 특정 방향을 따르는 매끄러운 표면을 얻는지를 설명하는 데 사용된다. 분열의 일반적인 예는 암석이 층을 이루는 경우입니다. 층리는 퇴적암의 층상 퇴적에 의한 1차 층리와 변성작용에 의한 2차 층리(예: 층상 편마암)로 분류됩니다.

분열 특성의 좋은 결과는 해당 위치에 존재하는 넓고 평평한 영역/표면을 관찰함으로써 확인할 수 있습니다.

 

낙각
낙각, 경사각은 암석 내 자연 표면(예: 층리면 또는 편마암)의 경사도를 나타내는 용어로, 각도로 측정됩니다. 이 각도는 수평면과의 관계를 기준으로 측정되며, 낙각 방향(경사 방향)은 표면의 수평선(연장 방향)에 수직을 이룹니다.

낙각은 층리가 발생하는 수평면과의 경사각을 의미합니다. 경사각은 단층 등에 의해 암석이 획득한 방향성에 따라 달라진다. 즉, 경사각은 0도(완전히 수평인 표면)부터 90도(수평면에 수직인 상태) 사이의 각도로 표기된다. 또한 경사의 진행 방향각, 즉 북(N), 동(E), 남(S), 서(W) 방향으로 표면을 따라 구르는 공의 진행 방향을 지정한다.


기타 의미
지질학과 관련하여 'fall'이라는 단어는 다음과 같은 의미로도 사용됩니다:

* 바다에서 얕은 암초, 파도가 부서지는 암석 뒤의 암초로, 간조 시에도 수면 아래에 있는 것이 바람직합니다. 많은 암초가 있으면 암초 군락(fall yard)을 이룹니다.

* 점토 및 토양과 결합된 용어: 산사태가 발생한 장소(점토 낙하, 산사태).

 

(경사각 그림)

경사각은 수평면을 기준으로 측정되며, 경사 방향은 층리 방향에 수직입니다.

 

이 캐시를 기록하려면.
이 캐시를 기록하려면 지오캐시에 제공된 좌표와 관련된 질문들을 방문하여 답변해야 합니다.

 

답변을 수집한 후, 확인을 위해 CO에게 보내주십시오.

답변을 CO에게 보낸 직후 기록할 수 있습니다. 답변에 대해 질문이 있을 경우 CO가 연락할 것입니다.

CO에게 답변을 제출하지 않았거나 CO의 미해결 질문이 있는 로그는 별도의 통보 없이 삭제됩니다.

질문에 대한 답이 될 수 있는 사진을 로그에 포함하지 마십시오.

 

질문:

1.  좌표(Coordinates)를 방문하여 아래 질문에 답하십시오.

 

A. GZ에서 산악 지형의 경사각 표면을 관찰하고, 그 결과가 1차 또는 2차 층리인지 설명하십시오.

B. GZ와 해당 지점의 평면상 경사각/절리면 경사각을 연구하십시오. 수평면으로부터의 각도를 대략 몇 도인지 표기하십시오. (도움을 위해 본문의 그림을 참고하십시오.)

C. 이제 경사각을 하늘/평면 방향에서 북(N), 북서(NW), 서(W), 남서(SW), 남(S), 남동(SE), 동(E), 북동(NE) 방향으로 정렬하십시오.

 

2. 답변 내용이 노출되지 않도록 현장에서 본인, 그룹 또는 GPS를 촬영하십시오.

 


 

The learning objective of this earthcache is to familiarize loggers with the geological concepts of dip angle and cleavage by studying the location at GZ.

The rock here shows a good and great example of dip angle, cleavage angle, and fracture angle. Dear child, it has many names but encompasses the same thing in a combination of how the rock has yielded and fractured. And with that, the rock will give off a dip angle that will be visible for us to study, as here at the location. Read through the text carefully to be able to answer the questions below.

 

Cleavage
Cleavage, specific surfaces along which a rock can be easily divided.

Cleavage is particularly pronounced in shale-like rocks, which can be taken out in large, thin flakes and used as slabs or roofing slates. Cleavage is also found in massive igneous rocks, such as granite, and enables the breaking of such rocks. The best cleavage in granite, for example, is horizontal or slightly inclined. After this, the natural bedding in the rock runs. At right angles to this is a less good cleavage. There may also be a third "wild cleavage" that is perpendicular to the other two.

Cleavage is therefore used to describe how a rock can split or divide within specific planes or zones of weakness so that smooth surfaces are obtained that follow these specific directions. A common example of cleavage is when the rock is layered. Layering can be categorized as either primary layering, such as sedimentary rocks due to layered deposition, and secondary layering, which is due to the rock being metamorphosed, such as layered gneiss.

A good result of cleavage properties will be seen by studying the large flat area/surface that is present at the location.

 

Fall
Fall, dip angle, expression for the inclination of a natural surface in a rock, for example a layered surface or a schist, measured in degrees. The angle is measured in relation to the horizontal plane, and the direction of the fall (dip direction) is perpendicular to the horizontal line in the surface (strike direction).

Fall is the angle of inclination relative to the horizontal plane in which the cleavage occurs. The dip angle depends on the orientation the rock has acquired after faults, etc. In other words, the dip angle is specified as a number of degrees between 0 (completely horizontal surface) to 90 degrees, corresponding to perpendicular to the horizontal plane. Furthermore, the heading angle of the fall is specified, i.e. the direction a ball would roll down the surface with a heading direction N,E,S,W.

 

Other meanings
In connection with geology, the word fall is also used in these meanings:

* Shallow in the sea, a reef after a rock that the ocean waves break on, preferably below the water surface even at low tide. If there are many falls, you have a fall yard.

* In compounds with clay and soil: a place where a landslide has occurred (clay fall, landslide).

 

(Illustrations of dip angle)

The dip angle is measured relative to the horizontal plane, and the dip direction is perpendicular to the direction of the stroke.

 

To log this cache.

To get to log this cache you will have to visit and answer the questions which are related to the coordinates given the earthcache.

When answers are collected, send them to CO for verification.

 

You can log immediately after answers are sent CO. If there are any questions about your answers CO will contact you.

Logs without answers to CO or with pending questions from CO will be deleted without any further notice.

Please do not include pictures in your log that may answer the questions.

 

Questions:

1.  Answer the questions under by visiting the Coordinates.

 

A. On GZ, you will now study the dip angle surface that we have here in the mountain and describe whether the results are of primary or secondary stratification?

B. Study GZ and the inclination angle of the dip angle/cleft on the plane we have at the location. What is the approximate angle given in degrees from the horizontal plane. (See the illustration in the text for help and guidance.)

C. Now you will orient the dip angle from the direction of the sky/plane towards N, NW, W, SW, S, SE, E, NE.

 

2.  Take a photo of you, the group or the GPS from the location without revealing any of the answers.

Additional Hints (No hints available.)